Kia Sportage 2008, Manual, Page: 61 / 227

7/6/12 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
61/227 https://www.kiatechinfo.com/viewer/toc_print.asp?vehicletype=Passenger&mfrcode=KM&area=KM…
(7) Turn the ignition switch to ON and check the vehicle again.
Does Hi­Scan (Pro) indicate any DTC related to FIS?
►
Go to next step.
►
Replace the Front Impact Sensor(FIS).
4. CLEAR THE DTC AND CHECK THE VEHICLE AGAIN
(1) Clear the DTC stored in the SRSCM memory with the Hi­Scan(Pro).
(2) Turn the ignition switch to LOCK and wait for at least 30 seconds.
(3) Turn the ignition switch to ON and wait for at least 30 seconds.
(4) Check the vehicle again with the Hi­Scan(Pro).
Does the above DTC(s) go off?
►
Problem is intermittent or was repaired and SRSCM memory was not cleared.
►
Replace the SRSCM with a new one, and then check the vehicle again. At this time, if the vehicle normally
operates with a new SRSCM, the fault may be the SRSCM(Replace SRSCM).
Restraint > Troubleshooting > B1335
DTC Description
The detecting system for front crash consists of the SRSCM and two Front Impact Sensors (FIS).
Inspection Procedure
If above DTC is detected , replace two Front Impact Sensors(FIS).
Restraint > Troubleshooting > B1346
DTC Description
The Driver Airbag circuit consists of the SRSCM, Clockspring and the Driver Airbag (DAB) which has two squib circuits.
The SRSCM sets above DTC(s) if it detects that the resistance of DAB squib is too high or low.
DTC Detecting Condition
DTC Condition Probable cause
B1346
B1347
• Too high or low resistance between DAB high(+) and DAB low (­)
• Driver Airbag (DAB) Malfunction
• Clockspring Malfunction
• SRSCM Malfunction
• Open or short circuit on
wiring harness
• Driver Airbag (DAB)
squib
• Clockspring
• SRSCM
Specification
DAB resistance : 1.5 ≤ R ≤ 5.7 Ω
Schematic Diagram