Kia Rio 2022, Owner'S Manual, Page: 451 / 602

25
7
7
What to do in an emergency If you have a flat tyre (with Tyre Mobility Kit)
NOTICE
Only use the front passenger side power
outlet.
10. With the ignition switched on or
ENGINE START/STOP button position
on: Switch on the compressor and let
it run for approximately 3 minutes to
fill the sealant. The inflation pressure
of the tyre after filling is unimportant.
11. Switch off the compressor.
12. Detach the hose from the sealant
bottle connector and from the tyre
valve.
Return the Tyre Mobility Kit to its storage
location in the vehicle.
WARNING
Carbon monoxide poisoning and suffo
-
cation is possible if the engine is left run
-
ning in a poorly ventilated or
unventilated location (such as inside a
building).
Distributing the sealant
13. Immediately drive approximately
7~10 km (4~6 miles or, about 10 min)
to evenly distribute the sealant in the
tyre.
CAUTION
Do not exceed a speed of 60 km/h (35
mph). If possible, do not fall below a
speed of 20 km/h (12 mph).
whilst driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road. Call for road side
service or towing.
When you use the Tyre Mobility Kit, the
wheel may be stained by sealant. There
-
fore, remove the wheel stained by seal
-
ant and have the vehicle inspected at a
professional workshop. Kia recommends
to visit an authorised Kia dealer/service
partner.
Checking the tyre inflation pres
-
sure
1. After driving approximately 7~10 km
(4~6 miles or about 10 minutes), stop
at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the filling
hose (3) (opposite side) to the tyre
valve.
OYB060012R ODEEV088017NR