Kia Rio 2022, Owner'S Manual, Page: 152 / 602

Features of your vehicle
74 4
Warning and indicator lights
CAUTION
If the light comes on continuously after
adding the engine oil and travelling
approximately 50 km, have the vehicle
inspected by a professional workshop as
soon as possible. Kia recommends to
visit an authorised Kia dealer/service
partner. Even if this light does not come
on after the engine has started, the
engine oil should be checked and sup
-
plied periodically.
Low Fuel Level Warning Light
This warning light appears:
When the fuel tank is nearly empty.
If the fuel tank is nearly empty:
Add fuel as soon as possible.
CAUTION
Low Fuel Level
Driving with the Low Fuel Level warning
light on or with the fuel level below “0 or
E” can cause the engine to misfire and
damage the catalytic converter. (if
equipped)
Low Tyre Pressure Warning Light
(if equipped)
This warning light appears:
僅 Once you set the ignition switch or
ENGINE START/STOP button to the
ON position.
- It appears for approximately 3 sec
-
onds and then goes off.
僅 When one or more of your tyres are
significantly underinflated.
* For more details, refer to "Tyre Pres
-
sure Monitoring System (TPMS) (if
equipped)" on page 7-8.
This warning light remains on
after blinking for approximately
70 seconds or repeats blinking
and off at the intervals of
approximately 3 seconds:
僅 When there is a malfunction with the
TPMS.
In this case, have the vehicle
inspected by a professional workshop
as soon as possible.
Kia recommends to visit an authorised
Kia dealer/service partner.
* For more details, refer to "Tyre Pres
-
sure Monitoring System (TPMS) (if
equipped)" on page 7-8.
WARNING
Safe Stopping
僅 The TPMS cannot alert you to severe
and sudden tyre damage caused by
external factors.
僅 If you notice any vehicle instability,
immediately take your foot off the
accelerator pedal, apply the brakes
gradually with light force, and slowly
move to a safe position off the road.
Forward Safety Warning Light
(if equipped)
This indicator light appears:
僅 Once you set the ignition switch or
ENGINE START/STOP button to the
ON position.