Kia PICANTO 2023, Manual, Page: 414 / 570

What to do in an emergency
24 7
If you have a flat tyre (with tyre mobility kit)
When the tyre and wheel are dam
-
aged, do not use Tyre Mobility Kit for
your safety.
CAUTION
Tyre pressure
Do not attempt to drive your vehicle if
the tyre pressure is below 230 kPa (33
psi). This could result in an accident due
to sudden tyre failure.
10.Switch off the compressor.
11.Detach the hoses from the sealant
bottle connector and from the tyre
valve.
Return the TMK to its storage location in
the vehicle.
WARNING
Carbon monoxide
Carbon monoxide poisoning and suffo
-
cation is possible if the engine is left run
-
ning in a poorly ventilated or
unventilated location (such as inside a
building).
Distributing the sealant
12.Immediately drive approximately
7~10km (4~6miles or, about 10min) to
evenly distribute the sealant in the
tyre.
CAUTION
Do not exceed a speed of 60 km/h (35
mph). If possible, do not fall below a
speed of 20 km/h (12 mph).
whilst driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the side of the road. Call for road side
service or towing.
When you use the Tyre Mobility Kit, the
tyre pressure sensors and wheel may be
stained by sealant. Therefore, remove
the tyre pressure sensors and wheel
stained by sealant and have the vehicle
inspected at a professional workshop.
Kia recommends to visit an authorised
Kia dealer/service partner.
Checking the tyre inflation pres
-
sure
1. After driving approximately 7~10 km
(4~6 miles or about 10 minutes), stop
at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the filling
hose (3) (opposite side) to the tyre
valve.
3. Connect between compressor and the
vehicle power outlet using the cable
and connectors.
4. Adjust the tyre inflation pressure to
230 kPa (33 psi). With the ignition
switched on, proceed as follows.
僅
To increase the inflation pres
-
sure: Switch on the compressor,
position I. To check the current
inflation pressure setting, briefly
switch off the compressor.
OJA060044