BODY PANEL REPAIR PROCEDURE
BP-9
4.
Preparation for spot welding
Remove paint on spot welded area and on the area
overlapped by the new part using a belt sander or
similar tool.
5.
Drilling a hole for plug welding
If the thickness of the part to be welded is less than 3
mm, drill a 5~6 mm diameter hole. If the thickness of
the part to be welded is greater than 3 mm, drill a hole
using a 7 mm diameter drill.
NOTE
Do not spot weld where thickness is greater than
3 mm.
BVQBP6020
BVQBP6021
PREPARATION FOR INSTALLATION
1.
Spot weld finish
Use a disk grinder or similar tool to finish spot weld
mark, Do not grind more than is necessary to smooth
surface.
2.
Panel preparation
Repair any bent or uneven areas with a hammer to
improve the installation process.
3.
Cutting a rough area for a new part
When rough cutting an area for a new part, leave a
tolerance of 30~50 mm.
BVQBP6017
BVQBP6018
BVQBP6019
mashinesoft.com
09120146259