Kia K900 2017, Features & Functions Manual, Page: 47 / 62

OTHER KEY FEATURES
45
*IF EQUIPPED ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
How to Sync Transmitter with HomeLink
®
If programming for the first time, begin with step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and hold the left F and center G buttons
simultaneously until the indicator light begins to flash (to
reprogram buttons, skip this step)
2. Press and hold the desired button F , G or H and hold
the button on the transmitter while it is approximately 1 to
3 inches away from the mirror. The HomeLink
®
indicator
light will flash rapidly once the frequency signal has been
successfully programmed
To finish programming rolling code garage door openers,
complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s
motor head unit. Press and release the button and complete
step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
®
button up to three times
Quick Tips
- You can reprogram a single HomeLink
®
button by
repeating step 2
- Erasing programmed buttons will delete all
trained transmitters
Operating HomeLink
®
:
Press one of the programmed HomeLink
®
buttons.
Erasing programmed buttons:
Press and hold the left F and center H buttons
simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
If your garage door opener was manufactured in 2011
or later, and you are unable to program your vehicle’s
HomeLink ® system, you may need to purchase a
HomeLink
®
Repeater Kit. For more information, go to
www.HomeLink.com or call (800) 355-3515.