Kia E-Soul, Owner'S Manual, Page: 434 / 574

7. Connect between compressor and
the vehicle power outlet using the
cable and connectors (4).
8. With the engine start/stop button
position on or ignition switch posi‐
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the “Tire
and Wheels” on page 9-07). The
inflation pressure of the tire after
filling is unimportant and will be
checked/corrected later.
Be careful not to overinflate the
tire and stay away from the tire
when filling it.
When the tire and wheel are dam‐
aged, do not use Tire Mobility Kit
for your safety.
CAUTION
n Tire pressure
Do not attempt to drive your vehicle
if the tire pressure is below 200 kPa
(29 psi). This could result in an acci‐
dent due to sudden tire failure.
9. Switch off the compressor.
10. Detach the hoses from the sealant
bottle connector and from the tire
valve.
Return the TMK to its storage location
in the vehicle.
WARNING
n Carbon monoxide
Carbon monoxide poisoning and suf‐
focation is possible if the engine is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
11. Immediately drive approximately
7~10 km (4~6 miles or, about
10min) to evenly distribute the
sealant in the tire.
CAUTION
Do not exceed a speed of 80 km/h
(50 mph). If possible, do not fall be‐
low a speed of 20 km/h (12 mph).
While driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road. Call for road side service or
towing.
When you use the Tire Mobility Kit,
the tire pressure sensors and wheel
may be stained by sealant. There‐
fore, remove the tire pressure sen‐
sors and wheel stained by sealant
and we recommend that inspect at
an authorized Kia dealer.
What to do in an emergency
7-18