Kia Cerato 2022, Owner'S Manual, Page: 219 / 622

135
4
4
Features of your vehicle Windscreen defrosting and defogging
The auto defogging system oper
-
ates when the heater or air condi
-
tioning is on.
When the Auto Defogging System oper
-
ates, the indicator will illuminate.
If a high amount of humidity is detected
in the vehicle, the Auto Defogging Sys
-
tem will be enabled.
The following steps will be performed
automatically:
1. The A/C button will turn ON.
2. The air intake control will change to
Fresh mode under low outside tem
-
perature.
3. The mode will be changed to defrost
to direct airflow to the windscreen.
4. The fan speed will be increased.
To cancel or reset the Auto Defogging
System
Press the front windscreen defroster
button for 3 seconds when the ignition
switch or ENGINE START/STOP button is
in the ON position.
When the Auto Defogging System is
cancelled, defrost button indicator will
blink 3 times.
When the Auto Defogging System is
reset, defrost button indicator will blink 6
times without a signal.
NOTICE
僅 When the air conditioning is turned on
by Auto defogging system, if you try
to turn off the air conditioning, the
indicator will blink 3 times and the air
conditioning will not be turned off.
僅 To maintain the effectiveness and
efficiency of the Auto Defogging Sys
-
tem, do not select Recirculation mode
whilst the system is operating.
僅 When the Auto Defogging System is
operating, the fan speed adjustment
knob, the temperature adjustment
knob, and the air intake control button
are all disabled.
NOTICE
Do not remove the sensor cover located
on the upper end of the driver side wind
-
screen glass.
Damage to system parts could occur
and may not be covered by your vehicle
warranty.
Sunroof inside air recirculation
The outside (fresh) air position is auto
-
matically selected, when the sunroof is
opened.When you select the recirculated
air position, the system maintains the
recirculated air position for 3 minutes
and then automatically converts to the
outside (fresh) air position.When the
sunroof is closed, the air intake position
will return to the original position that
was selected.
Automatic Air Ventilation
When operating heater and air condi
-
tioner for the vehicle ventilation, if you
maintain the Recirculation mode for 30
minutes or over at low temperature, it
automatically changes to Fresh mode.
Automatic Air Ventilation control
procedure
When set up or release the automatic air
ventilation function, select the Mode
Selection button at heater or air condi
-
tioner on. And press the Air Intake Con
-
trol button for 5 times or over within
3seconds together within 3 seconds
together within 3 seconds together with
pressing the Air conditioning button.
When release the automatic ventilation