Kia CERATO 2018, Owner'S Manual, Page: 196 / 602

• O/OFF:
Wiper is not in operation
• ---/
INT: Wiper operates intermit‐
tently at the same wiping
intervals. Use this mode in
light rain or mist. To vary
the speed setting, turn the
speed control knob.
• 1/LO: Normal wiper speed
• 2/HI:
Fast wiper speed
NOTICE
If there is heavy accumulation of
snow or ice on the windshield, de‐
frost the windshield for about 10
minutes, or until the snow and/or ice
is removed before using the wind‐
shield wipers to ensure proper oper‐
ation. If you do not remove the snow
and/or ice before using the wiper
and washer, it may damage the Wip‐
er and washer system.
Windshield washers (front)
In the O (Off) position, pull the lever
gently toward you to spray washer flu‐
id on the windshield and to run the wip‐
ers 1-3 cycles.
Use this function when the windshield
is dirty.
The spray and wiper operation will con‐
tinue until you release the lever.
If the washer does not work, check the
washer fluid level. If the fluid level is
not sufficient, you will need to add ap‐
propriate non-abrasive windshield
washer fluid to the washer reservoir.
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
CAUTION
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
WARNING
Do not use the washer in freezing
temperatures without first warming
the windshield with the defrosters;
(Continued)
Features of your vehicle
4-104