4 33
Features of your vehicle
4. With the compass heading displaying
normally, press and hold the button
(2) again for about 6~7 seconds until
the "CAL" appears and release the
button.
5. Drive your vehicle in at least 2~3 com-
plete circle (either clockwise or coun-
terclockwise) at less than 5 mph (8
km/h) until the "CAL" disappears, and
the compass heading appears then
calibration will be complete.
If the compass mirror does not recog-
nize the terrestrial magnetism correct-
ly depending on the external circum-
stances, it may be delayed in the cal-
ibration procedure.
6. If the vehicle's compass headings
become inaccurate again, repeat
above steps.
Setting the compass zone
This compass must be set to compen-
sate for the variation between true north
and magnetic north. To set variation:
1. Find your current location and vari-
ance zone number on the zone map.
2. Press and hold the COMPASS button
(2) for about 3 seconds until the
"ZONE" appears in the display, and
release the button. Then the zone
number will appear in the display.
3. Press the button (2) repeatedly until
the correct zone number for your loca-
tion appears in the display.
4. If the desired zone number is selected,
release the button (2). After about 3
seconds, the "ZONE" disappears and
a compass direction will be shown in
the display.
5. If the new compass zone is set, per-
form the "Calibration procedure".
✽
✽
NOTICE
• Do not install a ski rack, antenna, etc.
that is attached to the vehicle using a
magnet as anything attached to the
roof of the vehicle with a magnet will
effect compass operation.
• If the compass deviates from the cor-
rect indication after repeated adjust-
ment, have the compass checked at an
authorised dealer.
• The compass may not indicate the
correct compass point in tunnels or
while driving up or down a steep hill.
(The compass returns to the correct
compass point when the vehicle moves
to an area where the geomagnetism is
stabilised.)
OUN026137
OUN026138