background image

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

Assembly Instructions

WorkUp

®

 Adjustable Table 

Model CR

October 2019

Tools Required

•  #3 Phillips Screwdriver

•  5 mm Hex Key 

Note:

 Before discarding any 

packaging, confirm all components 

received against the packing list. 

Table assembly should be done on a 

soft, protective surface.  

Note:

 When tightening the  

M8 screws, first twist in all four 

screws “finger tight”. Then tighten 

the screws one quarter turn at a time 

using a diagonal tightening pattern 

as shown in Detail A. Repeat the 

diagonal pattern until all four screws 

are tight (Detail A & Figure 1).

Feet-to-Columns Assembly

   

1. Set a column on end with the smaller 

(inner) square tube on the floor. The 

threaded holes visible on the end of 

the column will be in a rectangular 

(not square) pattern (Figure 1). 

2. Place  the  foot  over  the  column                                                      

end so the column fits into the 

square hole in the foot. The slotted 

holes in the foot should line up with 

the four holes in the column end. If 

not the foot needs to be removed and 

repositioned at 90 degrees 

(Figure 1). 

3. Attach the foot using four  

M8 x 20 mm screws and four  

8 mm flat washers, tightening each 

screw one quarter turn at a time in a 

diagonal pattern until all four screws 

are tight (Figure 1 & Detail A). 

4. Thread leveling glides into the holes 

at the ends of the foot (Figure 1). 

Note: 

If the roller foot option was 

purchased, one foot will have  

pre-assembled rollers. 

5. Repeat steps 1 through 4 for the 

second foot and column (Figure 1).

Figure 1

leveling glide

foot

column

M8 x 20 mm

screw

8 mm flat

washer

Detail A

Reviews: