Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Assembly Instructions
Instruct
®
Classroom Furniture
All Terrain
®
Mobile Instructor’s Desk
February 2019
Landing Pad Installation
1. Locate the hardware pack for the
landing pad and identify the parts by
referencing Figure 1. Take special
note of the two different size landing
pad posts supplied and two different
size attachment bolts.
Important: The shorter landing
pad posts and bolts are to be
installed to the front, instructor-
side of the storage tower. The
instructor-side has the tower
door/opening in it.
2. Begin assembly by inserting
two
1
/
4
-20 x 4” bolts and two
1
/
4
-20 x 1
1
/
2
” bolts into the four
(upper) landing pad mount bushings
(Figure 1).
3. Locate the landing pad and identify
the side having the document ledge.
Secure the upper bushings with the
shorter
1
/
4
-20 x 1
1
/
2
” bolts to the
underside of the landing pad
with the document ledge using four
#8 x
1
/
2
” screws. Then secure the
upper bushings having the 4” bolts
to the underside at the rear of the
landing pad using four #8 x
1
/
2
”
screws (Figure 1).
Note: The top of all four
landing pad posts are angled
to correspond with the slope of
the landing pad on the storage
tower.
4. Place the flat, bottom sides of the
landing pad posts (two tall, and two
short) down onto the lower landing
pad post bushings as illustrated.
Position the shorter, landing pad
posts/bushings to the installed upper
bushings closest to the document
ledge at the underside of the landing
pad. Take care to orient the angled
edge of the posts correctly to
match the slope of the landing pad
underside (Figure 1).
5. Repeat the above procedure with
the longer landing pad posts,
positioning them to the rear upper
bushings at the 4” bolt locations
correctly matching the slope angle
(Figure 1).
6. Orient the landing pad with the
document ledge to the instructor-side
of the storage tower as illustrated.
Carefully position the landing pad
with installed bushings, posts &
bolts such that the four bolts insert
down through the four mounting
holes in the top of the tower
(Figure 1).
1
/ -20 x 4”
4
bolt
1
/ -20”
4
nut
1
/ ” flat
4
washer
1
/ ” flat
4
washer
1
/
4
-20
nut
1
1
/ -20 x 1 / ”
4
2
bolt
#8 x / ”
1
2
screw
storage
tower