background image

Assemble units as described herein only. To do otherwise 
may result in instability. All screws, nuts and bolts must be  
tightened securely and must be checked periodically after  
assembly. Failure to assemble properly, or to secure parts 
may result in assembly failure and personal injury.

Single-Piece Conference Table 

Assembly

Note: 

If a two-piece conference table 

is being assembled go to page 2:  

“Two-Piece Conference Table 

Assembly.” 

1. Carefully unpack all parts and 

identify the hardware required below 

from the “Hardware Pack” diagram. 

Set tabletop upside down on a soft 

protective surface. 

Note: 

One hardware pack is 

supplied per table base, to secure 

each base to the tabletop underside. 

2. Insert and twist four shoulder pin 

screws into the 5mm diameter  

pre-drilled holes in the underside of 

the tabletop as illustrated (Figure 1 

& Detail A). 

3. Carefully turn each table base upside 

down onto the tabletop one at a time, 

inserting the shoulder pin screws 

of the table into the corresponding 

camlock holes at the top edge of 

the table bases. Open the table base 

door and locate the camlocks inside 

the base, then twist each camlock 

clockwise to the 2 O’Clock position 

to lock (Figure 1 & Detail B). 

4. Once table bases are camlocked 

to the tabletop, identify the angle 

brackets inside the base, then twist in 

and tighten two #8 x 1” RWH screws 

per bracket, to further secure the 

base to the underside of the table as 

illustrated. After all 8 screws per base 

are tight, close the table base door 

(Figure 1 & Detail C). 

5. With the assistance of a second 

person, carefully turn the table 

upright and level the table as 

required.

Figure 1

Detail C

table base

tabletop

shoulder

pin screw

#8 x 1”

RWH screw

angle

bracket

cam

Detail A

shoulder

pin screw

Detail B

Step 1

Step 2

Rotate Camlock to
the 2 O’Clock position
to

lock.

FULLY

2 O

’Cloc

k

shoulder

pin screw

7HP39 - Hardware Pack

shoulder pin

screw

#8 x 1” RWH

screw

4

8

(one per base)

Assembly Instructions

Aristotle

®

 Casegoods

Conference Tables

January 2017

Reviews: