PASSWORD DOES NOT ALLOW ACCESS TO VICTRON APP:
• Log in with factory Default pin code 000000 to set new password.
• If the pin code is unknown or forgotten for the Smart Controller or the Smart Shunt the pin can be reset.
To be able to reset the PIN code you will need the enter the unique PUK code for the device to be reset.
The PUK code is printed on the product information sticker on the Smart Controller or Smart Shunt.
For further diagnostics refer to charge controller manual section 9 for detailed troubleshooting or consult dealer for
further assistance.
MY INVERTED OUTLETS ARE NOT POWERED WITH SHORE CORD
DISCONNECTED
• Make sure the inverter disconnect is switched to ON.
• The Victron inverter power switch has 3 settings On, Off, and
Charger Only. Ensure the Victron inverter is switched to ON and
not Charger Only or Off.
• Check to see if any of the branch circuit breakers in the
distribution center are tripped, if so reset.
• Check phone app to verify battery(s) are fully charged at 13.6
for lithium. If batteries are low, charge until full by shore cord, generator, or solar.
For additional troubleshooting refer to inverter troubleshooting guide. Or consult dealer for further assistance.
In partnership with
SOLARFLEX 600i-L BASIC
TROUBLESHOOTING GUIDE
USER MANUAL
VICTRON
• If these conditions are met and the problem remains, consult your dealer for further assistance.
• Ensure inverter disconnect is on.
• Check to see if any of the branch circuit breakers
in distribution center are tripped, if so reset.
MY ROOF AC IS NOT WORKING ON SOLAR OR MY INVERTED OUTLETS ARE
NOT WORKING:
• Ensure the solar panels are clean, in direct sunlight and free from obstruction/debris
• Ensure the batteries are fully charged, 13.6 for lithium
• Ensure the 12V unit battery disconnect black switch is on, located on interior wall near entrance door or in
front storage compartment.