26
Keysight X8712A IoT Device Battery Life Optimization Solution User’s Guide
N6705C Two-Channel Configuration for Non-RF Events
The following is a typical setup for non-RF events where it does not involve the
use of Channel 2. Use the following software settings:
– Channel 1: Battery emulator for DUT
– Channel 3 or 4: Voltage meter or Current meter according to your choice of
sensors
When Channel 3 or 4 is connected to the DUT, the software will use either channel
as synchronous events to calculate current consumption.
Follow the instructions below to set up the hardware as shown above.
1
Refer to
for instructions on how to install the SMU
modules into the N6705C DC power analyzer.
2
Use the test leads (not included) to connect your DUT to Channel 1 (Battery
Emulator).
3
Connect your voltage-based sensor to Channel 3 or 4 using
V+
and
V-
accordingly. Do the same when you are using a current-based sensor.
You have completed the hardware setup based on this example.
Go to
section to install the required software to operate the
X8712A IoT device battery life optimization solution.
