STATus Subsystem
11
STATus:QUEStionable:CONDition?
U3606A Programmer’s Reference
289
STATus:QUEStionable:CONDition?
Syntax
STATus:QUEStionable:CONDition?
This command queries the condition register for the Questionable Data
register group and returns a decimal value which corresponds to the
binary- weighted sum of all bits set in the condition register (
). For example, if bit 0 (decimal value = 1) and bit 2 (decimal
value = 4) are set, this command will return the decimal value “
+5
”.
Remarks
•
A condition register continuously monitors the state of the instrument.
The bits in the condition register are updated in real time and the bits
are not latched or buffered.
•
The condition register bits reflect the current condition of the
instrument. If a condition goes away, the corresponding bit is cleared in
the condition register. A Factory Reset (
*RST
command) will clear all
bits in the condition register.
Example
See also
“STATus:QUEStionable:ENABle” on page 290
“STATus:QUEStionable[:EVENt]?” on page 292
N O T E
This is a read-only register and the bits are not cleared when you read the
register. For more information on the bit definitions of the Questionable
Data register and the SCPI status diagram see the
.
&
STAT:QUES:COND?
This command reads the condition register
(bit 12 is set).
$
+4096
Summary of Contents for U3606A
