Keysight U2741A, Programmer'S Reference Manual

Page: 138 / 169

10 Other Commands
138 Keysight U2741A Programmer’s Reference Guide
ABORt
Syntax
ABORt
This command aborts a measurement in progress.
Remarks
– This command may be useful to abort a measurement when the U2741A is
waiting for a trigger.
– The
*RST
command will abort a measurement and set all measurement
parameters to their factory settings.
– When trigger source is set to
BUS
, the
INIT
command will change the state of
the triggering system from the “idle” state to the “wait-for-trigger” state. At
this time, if the
ABOR
command is issued,
*TRG
is not allowed, the U2741A will
return a system error –211, “Trigger ignored” .
Example
ABOR
//Aborts the measurement in progress
See Also
*RST