Keysight P9241, Scpi Programmer'S Manual

Page: 192 / 1344

192 Keysight P9241/42/43A Oscilloscopes SCPI Programmer's Guide
7
Root (:) Commands
:BLANk
(see page 1196 )
Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | FFT | SBUS{1 | 2}
| WMEMory<r>}
<n> ::= 1 to (# analog channels) in NR1 format
<m> ::= 1 to (# math functions) in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :BLANk command turns off (stops displaying) the specified channel, math
function, serial decode bus, or reference waveform location. The :BLANk command
with no parameter turns off all sources.
See Also • "Introduction to Root (:) Commands" on page 185
• ":DISPlay:CLEar" on page 304
• ":CHANnel<n>:DISPlay" on page 262
• ":FUNCtion<m>:DISPlay" on page 353
• ":SBUS<n>:DISPlay" on page 576
• ":WMEMory<r>:DISPlay" on page 1084
• ":STATus" on page 218
• ":VIEW" on page 221
Example Code • "Example Code" on page 221
NOTE
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay commands,
:CHANnel<n>:DISPlay, :FUNCtion:DISPlay, :SBUS<n>:DISPlay, or :WMEMory<r>:DISPlay, are
the preferred method to turn on/off a channel, etc.
NOTE
MATH<m> is an alias for FUNCtion<m>.