Keysight N9923A, User Manual, Page: 45 / 276

Keysight N9923-90001 User’s Guide
45
NA (Network Analyzer) Mode
NA Mode Settings
Quick Settings
Both CAT and NA Modes allow you to view and change most relevant settings
from a single location. All of these settings are discussed in this chapter and,
unless otherwise noted, ALL of these settings can also be made using the
standard softkey menus. In the graphic below, the resolution is being edited.
How to view and change Quick Settings
— Press Meas Setup 4
— Then Settings .
— Press Next Page and Previous Page to view all settings. If these softkeys
are NOT available, then all available settings fit on one page.
— To change a setting:
—Use the arrows to highlight a setting.
—Then press Edit . The current setting changes to yellow .
—Some settings require you to press a softkey to change the value.
Otherwise, use the numeric keypad, arrows, or rotary knob to
change the value.
—When finished changing a value, press Done Edit .
— Press
Dock Window
to relocate the Settings table to a position relative to
the trace window. The Dock Window setting persists through a Preset.
Choose from the following:
Interference Rejection and System Z0 can be changed ONLY from the
Quick Settings menu. Learn more about these settings in “System
Impedance (Z0)” on page 54
.
ALL other settings can also be made using
the standard softkey menus.