Installation Note N5242-90123
26
Installation Procedure for the Upgrade
Step 19. Install the Bulkhead Connectors and Jumper on the Rear Panel
1.
Remove hole plugs from the following rear panel connector openings:
—
PORT 4—SW TSET IN (J3)
—
PORT 4—SW SRC OUT (J4)
New parts are listed in
for this step of the procedure.
2.
Where the hole plugs had been, install bulkhead connector assemblies for the two new rear
panel cables. These cables will be installed later.
3.
Using a 5/16-in torque wrench set to 21 in-lbs, tighten the hex nuts on the bulkhead
connectors.
4.
Install the rear panel jumper, W113, on the bulkhead connectors and torque the jumper
connectors to 10 in-lbs.
