Keysight N4372E, User Manual, Page: 83 / 152

Keysight N4372E Lightwave Component Analyzer User’s Guide 83
User Interface Reference 5
Selecting Port Configuration
Pressing the button opens a dialog which allows you to select
the network analyzer ports to be used for the LCA Optical
Transmitter/Receiver as well as the DUT. Once open, the dialog shows the
current port configuration as it is configured on the LCA server. The LCA
server stores specific port configurations for EO-, OE- and OO-
measurements.
The assignment of source and receiver to either DUT or LCA in the
configuration table depends on which measurement tab the dialog was
opened from.
If ‘Single-Ended’ measurement is selected, two columns are shown where
you can select which port is connected to the source and which one is
connected to the receiver.
Figure 17 Single-Ended EO-measurement