Keysight M9502A, User Manual

Page: 38 / 142

28 Keysight M9502A/M9505A AXIe Chassis User Guide
Chassis Installation Installing Modules
To Remove a Module
The instructions below apply to all module types. The Embedded System Module
(ESM) has the same extraction handles and retaining screws as instrument
modules. If you should ever have to remove the ESM, follow the instructions for
instrument modules below.
1
Power down and unplug the AXIe chassis (see page 15 ).
2
Fully loosen the captive retaining screws on both sides of the module.
3
For a filler panel module, grasp the panel by the two captive retaining screws,
and slide it out of the chassis.
For all other modules, locate the insertion/extraction handles at each side of
the module’s front panel. Extend the plastic ends of both handles by sliding
them outward on their metal handle shafts, inwards towards each other.
4
Open the handles by pivoting them out towards you, away from the chassis.
Place each thumb at the inside of the handle, forefinger outside the handle,
and rotate the handles with your thumbs. When the handles are
perpendicular with the chassis, stop. The module should now be unseated the
module from the chassis backplane and its faceplate from the chassis front
panel.
Grasp the levers to slide the module out of the chassis.
Ensure you fully loosened the captive module retaining screws before trying to
extract any module. If you attempt to pull the module out by the screws (for
filler panels) or by using the extraction handles (other modules) with these
screws still engaged, damage to the chassis or module could result.