6
Keysight M9182A/M9183A Calibration and Verification Procedure
Do Not Operate Near Flammable Liquids
Do not operate the Keysight module/chassis in the presence of flammable liquids
or near containers of such liquids.
Do Not Remove Instrument Cover
Only qualified, service-trained personnel who are aware of the hazards involved
should remove instrument covers. Always disconnect the power cable and any
external circuits before removing the instrument cover.
Cleaning
Clean the outside of the Keysight module, chassis, or accessory with a soft,
lint-free, slightly dampened cloth. Do not use detergent or chemical solvents.
Keep Away From Live Circuits
Operating personnel must not remove equipment covers or shields. Procedures
involving the removal of covers and shields are for use by service-trained
personnel only. Under certain conditions, dangerous voltages may exist even with
the equipment switched off. To avoid dangerous electrical shock, DO NOT perform
procedures involving cover or shield removal unless you are qualified to do so.
DO NOT Operate Damaged Equipment
Whenever it is possible that the safety protection features built into this product
have been impaired, either through physical damage, excessive moisture, or any
other reason, REMOVE POWER and do not use the product until safe operation
can be verified by service-trained personnel. If necessary, return the product to an
Keysight Technologies Sales and Service Office for service and repair to ensure
the safety features are maintained.
