Keysight M8290A, Getting Started Manual, Page: 27 / 56

Keysight M8290A Getting Started Guide 27
Software Installation 2
Post Installation Steps
Follow the post installation steps as shown below:
1 Shut down the embedded controller.
2 Reboot the AXIe chassis.
3 The embedded controller should automatically recognize all available
M829xA modules. You may check this in the device manager; e.g. via
Start > Control Panel > Device Manager , or right-click Computer >
Manage > Device Manager .
The instruments should be visible in the device tree as Keysight
Technologies Modular Devices > M8296A or M8292A respectively.
4 Check if all installed M829xA modules are visible in the Connection
Expert . The connection expert can be opened by clicking its icon in the
system tray.
If something went wrong and any of the instruments does not appear
in the PXI section, it may be necessary to reboot the embedded
controller once more.
NOTE
To successfully connect the M829xA to the PC, the post installation
steps mentioned above must be strictly followed.
NOTE
Reboot your PC immediately, if requested to do so.