Keysight M8100A Series, Getting Started Manual

Page: 34 / 46

34 Keysight M8100A Series Arbitrary Waveform Generators Getting Started Guide
2 Basic Setup for M8100A
Step 7 - Connect Clock Source to M8199A Module
There are two possible ways to provide a clock source to the M8199A
module:
Case 1 : Connecting M8008A LSR clock module to M8199A module.
In this case, connect the 45 cm 1.85 mm blue clock cable
(M8199-61621) from Sample Clk Out of M8008A to Clk In of M8199A.
The following figure shows how to connect M8008A LSR clock module
to the M8199A module:
Case 2 : Connecting PSG to M8199A module.
In this case, connect the 45 cm 1.85 mm blue clock cable
(M8199-61621) from the PSG Output to Clk In of M8199A.
The output power needs to be set at the PSG for various sample clock
frequencies. The output power level should start at 7dBm at 50 GHz
and should be increased linearly to 11 dBm at 60 GHz. This means, as
we increase the frequency from 50 GHz to 60 GHz, there is a linear
increase in the output power from 7 dBm to 11 dBm. Above 60 GHz, a
power level of 11 dBm should be used.
M8008A
M8199A