M5300A PXIe RF AWG Modules Startup Guide
35
Setting up the M5300A module
2
2.2.3: Installing the Embedded Controller
Before installing the module, remove plastic thread protectors on the top
and bottom of mounting screws. Use the appropriate instructions below
for installing the embedded controller or the remote controller.
Figure 6
Front panel view of M9037A Embedded Controller
If your configuration contains a Keysight Embedded Controller (for
example, M9037A), follow the procedure below. For additional details,
refer to the instructions in the
.
1 Remove the M9037A module from its ESD protective bag. See
2 Install the embedded controller in Slot 1 (see the
icon above the
slot) in the chassis.
CAUTION
Do not power up the controller until instructed to do so later in this
document.
Summary of Contents for M5300A
