To define a non-VLAN subnet, do the following:
1. Click
Control Center
>
Network Neighborhood
from the BreakingPoint Control Center menu
bar.
2. Select a Network Neighborhood from the
Network Neighborhoods
list.
3. Select a test interface to modify by clicking the
Interface
tab.
4. Select a domain from the
Domains
list.
5. Click
Show the create new subnet form (‘+’)
located under the Subnets list. The
Create
new subnet
dialog box appears.
Note:
If you are adding a subnet to an empty domain, you can skip this step. The Subnet
form will already be blank and ready for you to input addressing information.
6. Select IPv4 or IPv6 addressing.
7. Click
VLAN Tagging
and select a VLAN tag.
8. Select Use NAT for network address translation (if applicable).
9. Type an IP address in the
Network IP Address
box. To assign an IPv4 address, use the format
x.x.x.x, where x is a number between 0-255. To assign an IPv6 address, use the format x:x:x:x,
where x is a valid hexadecimal value.
10. Type a mask for the network address in the
Netmask
box. For IPv6 addressing, type the prefix in
the
Prefix
field.
11. Type a gateway address in the
Gateway IP Address
box. To assign an IPv4 address, use the
format x.x.x.x, where x is a number between 0-255. To assign an IPv6 address, use the format
x:x:x:x, where x is a valid hexadecimal value.
Chapter 3 Getting Started
– 20 –
