Keysight E6961A, User Manual And Method Of Implementation

Page: 19 / 75

Overview 1
Keysight E6961A User Guide and Method of Implementation 19
Figure 1-5 BroadR-Reach Compliance Test Application Main Window
The Compliance Application software automatically sets frequency, etc. of the
external instruments (oscilloscope, ENA, generators, etc.) if they are properly
configured. Refer to “Appendix D: Using the E6960-66600 Frequency Divider
Board” on page 67.
The task flow pane, and the tabs in the main pane, show the steps you take in
running the automated tests:
Requires Frequency Divider
Board. See Appendix D:
Using the E6960-66600
Frequency Divider Board
67 .
Use
TX_CLK.
Check this if
your DUT
has its own
Transmit
Clock.
Otherwise,
the default
clock signal
is used.
Refer to
“Appendix C: External
Instrument Calibration” on
page 59.
Refer to
“Appendix B: Configure
External Instruments” on page 57.