Keysight E6650A EXF, User Programming Manual

Page: 632 / 657

6 List Sequence Measurements
Source
Step Configuration of Transition Time parameter list (Remote Command Only)
This SCPI command is to configure “Transition Time” parameter array of the whole List Sequencer at one
time. The number of array is same as step number defined in
"Number of Steps" on page 598 Number of
Steps. As a step is setup, the value entered run through several levels of validation.
Remote Command :SOURce:LIST:SETup:TRANsition:TIME <time>, <time>, <time>, …
:SOURce:LIST:SETup:TRANsition:TIME?
Example :SOUR:LIST:SET:TRAN:TIME 1ms,1ms,1ms
:SOUR:LIST:SET:TRAN:TIME?
Notes The command is to setup below parameter array of whole list sequence.
Transition Time < time > – specifies the transition time for the stepin seconds. For details of the valid
ranges for the transition time see "Transition Time" on page 601
If input parameter number exceeds the step number defined by "Number of Steps" on page
598 Number of Steps then generate error ", and only those parametes whose index number falls in
number of steps will be updated.
Dependencies The range is 1 to 1000 which is determined by the number of steps you have configured. For details
see
"Number of Steps" on page 598 .
Initial S/W Revision A.09.40
Step Configuration of Radio Band parameter list (Remote Command Only)
This SCPI command is to configure “Radio Band” parameter array of the whole List Sequencer at one time.
The number of array is same as step number defined in
"Number of Steps" on page 598 Number of Steps.
As a step is setup, the value entered run through several levels of validation.
R
e
m
o
t
e
C
o
m
m
a
n
d
:SOURce:LIST:SETup:RADio:BAND <enum>, <enum>, <enum>, …
:SOURce:LIST:SETup:RADio:BAND?
E
x
a
m
p
l :SOUR:LIST:SET:RAD:BAND PGSM, EGSM, RGSM
:SOUR:LIST:SET:RAD:BAND?
632 Sequence Analyzer User's & Programmer's Reference