
6 List Sequence Measurements
Meas Setup
Trig Slope
This parameter controls the trigger polarity for the External 2 trigger. It is set positive to trigger on a rising
edge, and negative to trigger on a falling edge.
parameter_table_23.52941
52.94118
Key Path
Meas Setup, Input Trigger Setup
Remote Command
:TRIGger:LSEQuencer:EXTernal2:SLOPe POSitive|NEGative
:TRIGger:LSEQuencer:EXTernal2:SLOPe?
Example
TRIG:LSEQ:EXT2:SLOP NEG
TRIG:LSEQ:EXT2:SLOP?
Preset
POSitive
State Saved
Saved in instrument state.
Initial S/W Revision
A.05.00
Help Map ID
35208
IF Gain
In order to take full advantage of the RF dynamic range of the test set’s analyzer, a switched IF amplifier
with approximately 10 dB of gain can be toggled. If it can be turned on without an overload, the dynamic
range is always better with it on than off. The IF Gain key can be used to set the IF Gain function to High
(High Gain - the extra 10 dB) or Low (Low Gain). These settings affect sensitivity and IF overloads.
This setting is not displayed for E6607C
parameter_table_23.53758
52.93301
Key Path
Meas Setup, IF Gain
Remote Command
[:SENSe]:LSEQuencer:IF:GAIN[:STATe] LOW|HIGH
[:SENSe]:LSEQuencer:IF:GAIN[:STATe]?
Example
LSEQ:IF:GAIN?
Notes
Not displayed for E6607C
Preset
LOW
State Saved
Saved in instrument state.
Readback Text
High Gain or Low Gain
Initial S/W Revision
A.05.00
Help Map ID
35213
Low Gain
Deactivates the FFT IF Gain.
Sequence Analyzer User's & Programmer's Reference
471