Keysight E6640A, Measurement Applications User & Programmer Reference

Page: 2691 / 2870

15 Power Control Measurement
Recall
After the recall completes, the message "Register <register number> recalled" appears in the message
bar. If you are in the Spectrum Analyzer Mode, and you are recalling a register that was saved in the
Spectrum Analyzer Mode, then after the recall, you will still be in the Recall Register menu. If the Recall
causes you to switch modes, then after the Recall, you will be in the Frequency menu.
If a requested register is empty an error is generated.
Key Path
Recall, State
Example *RCL 1
Range 1–16 from front panel, 1–128 from SCPI
Readback Date and time with seconds resolution are displayed on the key
OR
A custom name of up to 30 characters entered using the Save, State,Edit Register Names key
OR
“(empty)" if no prior save operation has been performed to this register.
Initial S/W Revision Prior to A.02.00
Modified at S/W Revision Prior to A.11.00
Sequences
These keys allow you to import a Tab separated or .txt file that will automatically setup all the parameters
required for building a Sequence. The parameters will automatically be loaded into the Stated Sequencer.
Once selected, in order to import the selected Sequence Type you must select the Open key in the Source
Sequence menu.
Key Path
Recall, Sequences
Mode All
Remote Command :MMEMory:LOAD:SEQuences: | SLISt | ALISt | SAAList | "MySequence.txt"
Example :MMEM:LOAD:SEQ:SLIS "MySequence.txt"
Notes Available file types are:
−
CSV (Comma delimited) (*.csv)
−
Text (Tab delimited) (*.txt)
Initial S/W Revision A.05.00
Source Sequence
The list of parameters, that configure steps, that makes up a sequence for the Source.
The Source sequence is a sequence of flexible configurable steps that can be set anywhere in the
instruments frequency range.
Key Path
Recall,Sequences
W-CDMA & HSPA Measurement Applications Reference 2691