Keysight E6640A, Measurement Applications User & Programmer Reference

Page: 1293 / 2870

10 Spectrum Emission Mask Measurement
Sweep/Control
Trig Holdoff
Sets the holdoff time between triggers. When the trigger condition is satisfied, the trigger occurs, the delay
begins, and the holdoff time begins. New trigger conditions will be ignored until the holdoff time expires.
For a free-running trigger, the holdoff value is the minimum time between triggers.
Key Path
Trigger, Auto/Holdoff
Remote Command
:TRIGger[:SEQuence]:HOLDoff <time>
:TRIGger[:SEQuence]:HOLDoff?
:TRIGger[:SEQuence]:HOLDoff:STATe OFF|ON|0|1
:TRIGger[:SEQuence]:HOLDoff:STATe?
Example TRIG:HOLD:STAT ON
TRIG:HOLD 100 ms
Dependencies Unavailable if the selected Input is BBIQ. If this is the case, the key is grayed out if it is pressed the
informational message “Feature not supported for this Input” is displayed. If the SCPI command is
sent, the error “Settings conflict; Feature not supported for this Input” is generated.
Preset Off, 100 ms
State Saved Saved in instrument state
Min 0 s
Max 0.5 s
Default Unit s
Initial S/W Revision Prior to A.02.00
Gate Preset (Remote Command Only)
Presets the time-gated spectrum analysis capability.
This command sets gate parameter values to the ESA preset values, as follows:
Gate trigger type = edge
Gate polarity = positive
Gate delay = 1 us
Gate length = 1 us
Remote Command [:SENSe]:SWEep:TIME:GATE:PRESet ESA Compatibility
Initial S/W Revision Prior to A.02.00
Gate Level (Remote Command Only)
Sets the gate input transition point level for the external TRIGGER inputs on the front and rear panel. This is
a legacy command for PSA compatibility. It is simply an alias to the equivalent trigger level command.
W-CDMA & HSPA Measurement Applications Reference 1293