Keysight E3632A, User Manual

Page: 152 / 196

4 Error Messages

Execution Error Messages
130 E3632A User’s Guide
Execution Error Messages
Table 4-1 Execution error messages
-101 Invalid character
An invalid character was found in the command string. You may have inserted a character such as #, $,
or % in the command keyword or within a parameter.
Example:
OUTP:STAT #ON
-102 Syntax error
Invalid syntax was found in the command string. You may have inserted a blank space before or after a
colon in the command header, or before a comma.
Example:
VOLT:LEV, 1
-103 Invalid separator
An invalid separator was found in the command string. You may have used a comma instead of a colon,
semicolon, or blank space, or you may have used a blank space instead of a comma.
Example:
TRIG:SOUR,BUS
or
APPL 1.0 1.0
-104 Data type error
The wrong parameter type was found in the command string. You may have specified a number where a
string was expected, or vice versa.
-105 GET not allowed
A Group Execute Trigger (GET) is not allowed within a command string.
-108 Parameter not allowed
More parameters were received than expected for the command. You may have entered an extra
parameter, or added a parameter to a command that does not accept a parameter.
Example:
APPL? 10
-109 Missing parameter
Fewer parameters were received than expected for the command. You omitted one or more parameters
that are required for this command.
Example:
APPL
-112 Program mnemonic too long
A command header was received which contained more than the maximum 12 characters allowed.