Keysight E1412A, User'S Manual And Scpi Programming Manual, Page: 190 / 243

cxc Keysight E1412A Digital Multimeter User Guide
Multimeter Command Reference TRIGger
TRIGger
The TRIGger command subsystem controls the behavior of the trigger system.
The subsystem can control:
–
The number of triggers to occur before the multimeter returns to the idle
state (
TRIGger:COUNt ).
– The delay between trigger and measurement ( TRIGger:DELay ).
– The source of the trigger ( TRIGger:SOURce ).
Subsystem Syntax
TRIGger
:COUNt <
number
>|MIN|MAX|INFinite
:COUNt? [MIN|MAX]
:DELay <
seconds
>|MIN|MAX
:DELay? [MIN|MAX]
:DELay:AUTO OFF|ON
:DELay:AUTO?
:SOURce BUS|IMMediate|EXTernal|TTLTrg0-7
:SOURce?
:COUNt
TRIGger:COUNt <
number
>
sets the number of triggers to be issued.
Parameters
Comments
– MIN selects 1 trigger. MAX selects 50,000 triggers.
– If MAX or 50,000 is specified for the number parameter, the command will
be accepted. If you initiate measurements with an INITiate command, an
“Insufficient memory” error occurs to show that this generates too many
readings to store in memory. However, you can use the
READ? command
to return the readings to the output buffer and retrieve them with your
controller. The
READ? command is a combined INITiate and FETCh?
command.
– CONFigure and MEASure set the trigger count to 1.
– *RST Condition: TRIG:COUN 1
Parameter Name Parameter Type Range of Values Default
Units
<
number
>
numeric 1 through 50,000|
MIN|MAX|INF
none