Vertical Controls
3
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
49
To turn waveforms on or off (channel or math)
1
Press an analog channel key turn the channel on or off (and to display the
channel's menu).
When a channel is on, its key is illuminated.
To adjust the vertical scale
1
Turn the large knob above the channel key marked
to set the vertical
scale (volts/division) for the channel.
The vertical scale knob changes the analog channel scale in a 1-2-5 step
sequence (with a 1:1 probe attached) unless fine adjustment is enabled (see
change the vertical scale knob's coarse/fine adjustment setting"
The analog channel Volts/Div value is displayed in the status line.
The default mode for expanding the signal when you turn the volts/division knob
is vertical expansion about the ground level of the channel; however, you can
change this to expand about the center of the display. See
To adjust the vertical position
1
Turn the small vertical position knob ( ) to move the channel's waveform up or
down on the display.
NOTE
Turning channels off
You must be viewing the menu for a channel before you can turn it off. For example, if channel
1 and channel 2 are turned on and the menu for channel 2 is being displayed, to turn channel
1 off, press
[1]
to display the channel 1 menu; then, press
[1]
again to turn channel 1 off.
