Cursors
14
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
149
In the Cursor Units menu:
You can press the
X Units
softkey to select:
•
Seconds (s)
.
•
Hz (1/s)
.
•
Phase (°)
— when selected, use the
Use X Cursors
softkey to
set the current X1 location as 0 degrees and the current
X2 location as 360 degrees.
•
Ratio (%)
— when selected, use the
Use X Cursors
softkey to
set the current X1 location as 0% and the current X2
location as 100%.
You can press the
Y Units
softkey to select:
•
Base
— the same units used for the source waveform.
•
Ratio (%)
— when selected, use the Use
Y Cursors
softkey to
set the current Y1 location as 0% and the current Y2
location as 100%.
For phase or ratio units, once the 0 and 360 degree or 0 and 100% locations are
set, adjusting cursors will display measurements relative to the set locations.
7
Adjust the selected cursor(s) by turning the Cursors knob.
