![Keysight 34460A Operating And Service Manual Download Page 358](http://html1.mh-extra.com/html/keysight/34460a/34460a_operating-and-service-manual_1961230358.webp)
[SENSe:]TEMPerature:APERture {<
seconds
>|MIN|MAX|DEF}
[SENSe:]TEMPerature:APERture? [{MIN|MAX|DEF}]
Specifies the integration time in seconds (called
aperture time
) for temperature measurements.
Use this command for precise control of the DMM's integration time. Use NPLC (see
) for better power-line noise rejection characteristics
(NPLC > 1).
Parameter
Typical Return
(
Without
the DIG option) 200 µs to 1 s (2 µs resolution), default: 100 ms. (
With
the DIG
option) 20 µs to 1 s (2 µs resolution), default: 100 ms.
+1.00000000E-
01
Enable aperture, set the aperture time to 300 ms:
TEMP:APER:ENAB ON
TEMP:APER 300E-03
l
Applies only to the 34465A and 34470A.
l
Both the [SENSe:]<
function
>:NPLC and [SENSe:]<
function
>:APERture commands control the instru-
ment's integration time. When using both commands (not recommended), whichever command is
sent last will override the other command and set the integration time. Sending the
[SENSe:]<
function
>:APERture command sets the [SENSe:]<
function
>:APERture:ENABled command
to 1 (ON); sending [SENSe:]<
function
>:NPLC sets it to 0 (OFF).
l
This parameter is set to its default value after a Factory Reset (
) or Instrument Preset
(
).
[SENSe:]TEMPerature:APERture:ENABled {ON|1|OFF|0}
[SENSe:]TEMPerature:APERture:ENABled?
Enables the setting of integration time in seconds (called
aperture time
) for temperature measurements.
If aperture time mode is disabled (default), the integration time is set in PLC (power-line cycles).
Parameter
Typical Return
{ON|1|OFF|0}. Default: OFF. 0 (OFF) or 1 (ON)
Enable aperture time mode, set the aperture time to 300 ms:
TEMP:APER:ENAB ON
TEMP:APER 300E-03
l
Applies only to the 34465A and 34470A.
l
The
,and
commands
disable the aperture time mode, and select an integration time in number of power line cycles.
l
This parameter is set to its default value after a Factory Reset (
) or Instrument Preset
(
).
Keysight True
volt
Series Operating and Service Guide
359
SCPI Programming Reference