Keysight 1000 Series, User Manual

Page: 96 / 156

96 Keysight 1000 Series Oscilloscopes User’s Guide
4
Making Measurements
Displaying Automatic Measurements
You can use the [Measure] key to display automatic measurements. The
oscilloscope has 22 automatic measurements and a hardware frequency counter
(see “Voltage Measurements" on page 98 and “Time Measurements" on
page 101).
To display an automatic measurement
1 Press [Measure] .
2 In the Measure menu, press Source to select the input channel on which to
make the automatic measurement.
3 Press Voltage (for voltage measurements) or Time (for time measurements) and
turn the entry knob to select the desired measurement.
4 Then, either push the entry knob or press Voltage or Time again to add the
measurement to the bottom of the display.
If the measurement result is displayed as "*****", the measurement cannot be
performed with the current oscilloscope settings.
A maximum of three measurements can be displayed at the bottom of the display.
When three measurements are displayed and you add a new one, the
measurements shift to the left, pushing the first measurement result off screen.
Figure 39 [Measure] Key
Menu
Zoom
Cursors Measure Acquire Display Help
Utility
Print
Save
Recall
Default
Setup
Auto-
Scale
Run
Stop
Single
Push Push
Push
for Zoom to Zero
for 50%