Keysight 1000 Series, User Manual

Page: 108 / 156

108 Keysight 1000 Series Oscilloscopes User’s Guide
4
Making Measurements
3 Continue pressing the Mode softkey or turn the entry knob to select
“Manual”.
4 Press Type to toggle between:
5 Press Source , and continue pressing the softkey or turn the entry knob to
select the channel or math waveform on which to make the measurement.
6 To adjust the cursors:
• Press CurA and turn the entry knob to adjust the “A” cursor.
• Press CurB and turn the entry knob to adjust the “B” cursor.
• Press CurA and CurB and turn the entry knob to adjust both cursors at the
same time.
The cursor values displayed are:
• CurA.
• CurB.
•
Δ X or Δ Y — difference between CurA and CurB values.
• 1/ Δ X — when measuring time parameters, shows the frequency associated with
the time period.
To use tracking cross-hair cursors
You can set up one or two manually adjustable, tracking cross-hair cursors to
make amplitude (vertical) and time (horizontal) measurements at different points
of a selected channel’s waveform.
1 Press [Cursors] .
2 In the Cursors menu, press Mode .
3 Continue pressing the Mode softkey or turn the entry knob to select “Track”.
4 Press Cursor A , and continue pressing the softkey or turn the entry knob to
select the channel on which to make the measurement (or “None” to turn off
the cursor).
Time To use cursors to measure time parameters.
Amplitude To use cursors to measure amplitude parameters.