20 Keysight CXG, EXG, and MXG X-Series Signal Generators Programming Guide
Getting Started with Remote Operation
IO Libraries and Programming Languages
VISA Configuration (Automatic)
1.
Run the VISA Assistant program.
2.
Click on the interface you want to use for sending commands to the signal
generator.
3.
Click the
Formatted I/O
tab.
4.
Select
SCPI
in the
Instr. Lang.
section.
You can enter SCPI commands in the text box and send the command using
the
viPrintf
button.
VISA Configuration (Manual)
Perform the following steps to use IO Config and VISA to manually configure an
interface.
1.
Run the
IO Config
Program.
2.
Click on
GPIB
in the
Available Interface Types
text box.
3.
Click the
Configure
button. Set the
Default Protocol
to
AUTO
and then
click
OK
to use the default settings.
4.
Click on
GPIB0
in the
Configured Interfaces
text box.
5.
Click
Edit...
6.
Click the
Edit VISA Config...
button.
7.
Click the
Add device
button.
8.
Enter the GPIB address of the signal generator.
9.
Click the
OK
button in this form and all other forms to exit the IO Config
program.
Summary of Contents for X-Series
Page 4: ...4 ...
Page 10: ...10 Contents ...
