U3042AM04
Controlling the Test Set with
N5222/32/42A/B
SCPI
Control
The Command Processor feature allows you to send remote commands and data to
the PNA rear-panel GPIB connector and Test Set I/O connector. More information
regarding the Command Processor can be found in the PNA Help menu.
Overview of the
SCPI
Control
The Command Processor allows you to send address and data to control an external
test set without needing to create a remote program. The user is required to
manually input address and data using the Command Processor Console in the PNA
Help menu.
•
Command Processor settings can not be saved or recalled.
•
Address and data can be
written
from the Command Processor.
How to Access Command Processor
1.
To access the Command Processor select
Utility > System > Configure >
SICL/GPIB/SCPI -OR-
(System Setup > Remote Interface > SCPI Monitor Input > Show SCPI Parser Console)
2.
Check the SCPI Command Processor Console box.
Figure 3
5
37
Keysight U3042AM04 User's and Service Guide
Command Console for 'A' Model Analyzers
