U3020AS62
Controlling the Test Set
Controlling the Test Set
Controlling the Test Set and Making Measurements
Keysight U3020A is a “
secondary
” instrument. A controller must be used to control the Test
Set. There are two methods that can be used to control the Test Set.
•
Using LAN connection
•
Using GPIB connection
Once the connection between the Controller and the Test Set has been established (LAN or
GPIB), the Test Set can be controlled using SCPI commands.
LAN Connection using Your Company's Intranet
Connect the Test Set and your controlling computer to an active instrument LAN line. Open the
internet browser application on the computer. Enter this default web address on your browser
application: http://U3020aS62-xxxx
The Welcome screen for the instrument should be viewable if the LAN connection is working.
Select the following screen control buttons to access the SCPI command control window.
1. Browser Web Connect (control button on the left side of the screen)
2. Allow Full control
3. Commands
The last four digits in the web address (xxxx) are the last four digits of the
instrument's serial number.
Once the connection between the controller and the Test Set has been established (LAN or
GPIB), the test set can be controlled using SCPI commands. Refer to
Keysight U3020AS62 User's and Service Guide
13
