1-
U3020AS16
Instrument Settings
Domain Name Command
This command assigns a Domain Name to the U3020A. The Domain Name is
translated into an IP address.
Syntax
:
SYSTem:COMMunicate:LAN:DOMain "<name>"
SYSTem:COMMunicate:LAN:DOMain?
If you change the Domain Name, you must cycle power on the U3020A to
activate the new address.
Example
:
The following command defines the Domain Name:
SYST:COMM:LAN:DOM
"
www.
k
eysight.com
"
The following query returns the Domain Name currently being used by the
instrument:
SYST:COMM:LAN:DOM?
Typical response: www.
k
eysight.com
Gateway Address Command
This command assigns a Default Gateway for the U3020A. The specified IP
Address sets the Default Gateway which allows the instrument to
communicate with systems that are not on the local subnet. Thus, this is the
Default Gateway where packets are sent which are destined for a device not on
the local subnet, as determined by the Subnet Mask setting. Contact your
network administrator to determine if a gateway is being used and for the
correct address.
Syntax
:
SYSTem:COMMunicate:LAN:GATEway <address>
SYSTem:COMMunicate:LAN:GATEway?
Example
:
The following command sets the Default Gateway address:
SYST:COMM:LAN:GATEWAY 255.255.20.11
The following query returns the Default Gateway address currently being used
by the instrument (the quotes are also returned).
SYST:COMM:LAN:GATEWAY?
Typical Response: "255.255.20.11"
28
Keysight U3020AS16 User's and Service Guide
