Keysight Technologies P9241A, Startup Manual

Page: 34 / 54

34 Keysight P9241/42/43A Oscilloscopes Startup Guide
7
Make a Measurement
In the Default Menu, there are also options for restoring the complete factory
settings.
Use Autoscale
Use Autoscale to automatically configure the oscilloscope to best display the input
signals.
1
Choose Main Menu > Autoscale .
You should see a waveform on the oscilloscope's display similar to this:
Table 1 Default Configuration Settings
Horizontal Normal mode, 100 µs/div scale, 0 s delay, center time reference.
Vertical (Analog) Channel 1 on, 5 V/div scale, DC coupling, 0 V position, 1 M Ω impedance.
Trigger Edge trigger, Auto trigger mode, 0 V level, channel 1 source, DC coupling, rising
edge slope, 40 ns holdoff time.
Display Persistence off, 20% grid intensity, 50% waveform intensity.
Other Acquire mode normal, Run/Stop to Run, cursors and measurements off.
Labels All custom labels that you have created in the Label Library are preserved (not
erased), but all channel labels will be set to their original names.