Keysight Technologies N9340B, User Manual

Page: 30 / 172

System and File

System Setting
24
System Setting
This section provides you the basic system configuration
which is frequently used before or after the
measurement operation. Please refer to the description
below to get a better user experience and ease your test
and measurement.
Power On and Preset Settings
Selecting a preset type
Press [SYS] > {Setting} > {PwrOn/Preset} > {Preset Type}
to choose the preset types. The analyzer has three types
of preset setting for you to choose from:
DFT Restores the analyzer to its factory-defined
setting. The factory default settings can be found,
"Factory Default Settings" on page 11 .
User Restores the analyzer to a user-defined setting.
Refer to the descriptions as below.
Last Restores the analyzer to the last time setting.
Saving a User-defined Preset
If you frequently use system settings that are not the
factory defaults, refer to the following steps to create a
user-defined system settings that can be easily recalled
at the power up state:
1 Set analyzer parameters by the knob, the arrow keys
or the numeric keypad.
2 Press [SYS] > {Setting} > {PwrOn/Preset} > {Save
User} to save the current parameters as the user
preset setting.
3 Press [SYS] > {Setting} > {PwrOn/Preset} > {Preset
Type User} to set the preset mode to user defined
system setting.
4 Press [Preset], the instrument will be set to the state
you previously saved.