Keysight Technologies N5247B, Service Manual

Page: 504 / 566

7-60 Keysight N5247B Service Guide
Repair and Replacement Procedures
Removing and Replacing the A55 Solid State Drive (SSD)
7-
Removing and Replacing the A55 Solid State Drive (SSD)
Certain unique files exist on the SSD that are necessary for proper operation of
your analyzer. These files must be copied to another location to allow them to
be installed onto the new SSD after it has been installed.
If you are replacing the SSD, the following procedure must be performed first.
Copy Unique Files from the Solid State Drive
— If installing an SSD for Windows XP: if the user has loaded unique
calibration kit information, navigate to
C:\Program
Files\Keysight\Network Analyzer
and copy USER_CALKITFILE to a
USB flash memory drive. Also copy any personal user files that you wish to
preserve.
Obsolete. Reference only.
— If installing an SSD for Windows 7: for more information on the N8984A
SSD, refer to the Windows 7 Operating System Upgrade Kit Installation
Note , available online at
https://www.keysight.com/us/en/assets/9018-04311/installation-guides
/9018-04311.pdf (N8984-90001).
Obsolete. Reference only.
— If installing an SSD for Windows 10: for more information on the N8985A
SSD, refer to the Windows 10 Operating System Upgrade Kit Installation
Note , available online at
https://www.keysight.com/us/en/assets/9018-04733/installation-guides
/9018-04733.pdf (N8985-90001).
Tools Required
— T-10 TORX driver (set to 9 in-lb; for solid state drive replacement)
— ESD grounding wrist strap
Removal Procedure
Refer to Figure 7-30 for this procedure.
1. Disconnect the analyzer power cord.
2. Position the analyzer for access to the rear panel.
3. Loosen the SSD thumb screw (item

).
4. Pull the SSD out from the CPU assembly, using the handle (item

).