28 Installation Note N5222-90128
Installation Procedure for the Upgrade
-
Refer to
for this step of the procedure. New parts are listed in
. Use a T-10 TORX driver to remove all screws.
2.
Remove 5023-3299 (x2) clamps and 0515-2141 (x2) clamp screws as
shown (item
➂
).
3.
Remove the W177 – N5240-60097 (x1) cable as shown. Note the
orientation of the cable (item
➁
). Save this cable for reuse.
4.
Remove the W174 – N5240-60098 (x1) cable as shown. Note the
orientation of the cable (item
➀
). Save this cable for reuse.
Figure 9
Remove the cables and clamps to the bias tee combiners (N5240-60098,
N5240-60097, 5023-3299, and 0515-2141)
These cables are reused, but the cable routing is different for a 4-port
instrument.
