Keysight Technologies N108 A Series, Getting Started, Page: 30 / 78

30 N108xA-Series Getting Started
2
Installing Both N108xA and N1010A FlexDCA on a PC
Step 12. Connect to the N4877A
1
In the compliance application’s Set Up tab, click the Connect N4877A button that is located at the
bottom of the window.
2
Enter the full SICL address or VISA alias. Or, select Select from Keysight Connection Expert as shown in
Figure 24 .
3
Click Identify to confirm the connection.
Figure 24 N4877A Selected from Connection Expert
4
Click OK to close the dialog box.
NOTE
Skip this step if your test setup uses an 86108A/B module. The N4877A Clock Data Recovery & Demultiplexer is
used whenever two 86100D modules are used in the test setup rather than an 86108A/B module. Refer to Table 3
on page 12.