Keysight Technologies M9195A PXIe, Startup Manual

Page: 35 / 46

Keysight M9195A/B PXIe Digital Stimulus/Response Startup Guide 29
High-Level Diagnostic Tools, Processes and References
If the status LED does not go from solid green to solid blue after the Soft
Front Panel comes up and connects with the M9195A/B, there may be an
LED problem. If the Soft Front Panel does not come up, see “Check
Software Installation” on page 30.
If the LED goes solid blue and the Soft Front Panel comes up, check that
the drivers are loaded correctly by flashing the blue LED from the SFP.
See “Check Module Status LED” on page 31.
If an incorrect LED condition repeats and continues, go to “Returning a
module for service” on page 7.
2
Does the M9195A/B appear correctly on Keysight Connection Expert ?
– Bring up Connection Expert and click on the “PXIe/AXIe Chassis” tab then
check to see if the M9195A/B in question appears in the correct slot.
If the module is not visible, try shutting down the system, cycling power,
and re-starting.
If the M9195A/B still does not show up in
Connection Expert then
power down the chassis and repeat the process with the M9195A
/B
installed in another slot.
If the M9195A/B does not show up in
Connection Expert , but the Soft
Front Panel (SFP) connects to it, then “Check Software Installation” and,
if necessary, re-install all required software in the order describe in the
M9195A/B Startup Guide .
If the Module continues to not show up in Connection Expert , go to
“Returning a module for service” on page 7.
3
Does the M9195A/B (SFP) connect?
If the
Connection Expert as well as the SFP does not connect, go through
Step 2 above.
– If the SFP fails to connect to the M9195A/B, then “Check Software
Installation” on page 30 and, if that is OK, try repeating the process with
the M9195A/B installed in another slot.
Re-install all required software in the order describe in the M9195A/B Startup
Guide .
– If the SFP connects, go to “Troubleshooting with the Soft Front Panel” on
page 31.