Keysight M9195A/B PXIe Digital Stimulus/Response Startup Guide
13
Step 4: Install the Module
Step 4: Install the Module
Chassis requirements for temperature control
The following chassis requirements assure optimal cooling and proper operating
temperatures for the DSR module:
-
Any empty module slot in the chassis should be fitted with a slot blocker (from
kit Y1212A) and EMC filler panel (from kit Y1213A).
-
If a PCIe Cable Interface module is used in place of a controller, the open area
to the left of the interface module should be filled with the filler panel and
bracket (from kit Y1214A).
-
All lower and side vents should remain unobstructed.
-
Set the chassis fan speed to HIGH. The fan switch is on the rear panel of the
M9018A chassis.
The use of a Keysight M9018A Chassis and the above accessories will optimize
module temperature performance.
When you restore power,
power up the chassis first -
before you
power up the host (controller) PC.
PXI hardware does not support “hot-swap” (changing modules
while power is applied to the chassis) capabilities. Before
installing or removing a module to/from the chassis, power off the
chassis to prevent damage to the module.
When powering-up the PXI chassis and during the first DSR driver
initialization after power-up (from the IVI API or from the
M9195A/B Soft Front Panel) make certain that no device–under–
test (DUT) is connected to the M9195A/B module.
Summary of Contents for M9195A PXIe
Page 45: ......
